NORM: the lead I used to build my shield with. :)

Share your spectra and discuss their features here
stamasd
Posts: 124
Joined: 29 Oct 2017, 02:12

NORM: the lead I used to build my shield with. :)

Post by stamasd » 05 Nov 2026, 02:19

I have built my lead castle using 4 large bricks of lead, 50lbs/23kg each, plus a number of smaller lead slabs of 10 pounds/4.5kg each. After building it in the shape I wanted, I was left with a few of the smaller 10lbs slabs.
I was curious what the lead itself may contain in terms of radioactive impurities. So I took a 12h background reading with the empty castle (including an inner layer of copper) and then put inside 2 of the leftover lead slabs, because that's all I could fit - so around 20lbs/9kg of lead inside the castle (inside the copper lining, next to the detector) and took another 12h reading.

Here is the result below. There's the K-40 peak at 1460keV, and a 511keV peak where it's expected to be. Apart from that, I can see a little evidence of a peak at 194keV which may be Ra-226, and one at 609keV likely from Bi-212. But they are very small above the continuous background spectrum. So I may be able to say that there is a little uranium contamination of the lead, but not much. The number of counts in the peaks is less than 500-600 over 12h above the subtracted background.

The origin of the lead is mostly recycled bullets, plus some other sources such as recycled car tire wheel weights and so, according to the seller I got it from. There's probably a small percentage of antimony in the lead, 5-6% as it's commonly added to harden the bullet alloy.
Not very exciting I know, but here it is.
Pb-20lbs-12h-2inCsI-1300V-130vol-pbcu-43200s.png
You do not have the required permissions to view the files attached to this post.

stamasd
Posts: 124
Joined: 29 Oct 2017, 02:12

Re: NORM: the lead I used to build my shield with. :)

Post by stamasd » 05 Nov 2026, 09:00

FWIW, I also tested today a block of 500g industrial graphite. That showed surprisingly little activity. Seems quite clean and free of intrinsic radioisotopes. There is a little peak at 609keV for Bi-214, but only 60 counts over 6h which is actually the same as the excess counts from K-40 that it registered.

User avatar
Peter-1
Posts: 172
Joined: 07 Oct 2016, 01:45

Re: NORM: the lead I used to build my shield with. :)

Post by Peter-1 » 08 Nov 2026, 01:54

A block of tungsten, which served as shielding in a radiation laboratory, produced a clear spectrum of thorium. The block weighs 2.7 kg. I was able to measure similar spectra in other pieces; these are likely impurities introduced during the tungsten manufacturing process. Unfortunately, it is not suitable for effectively shielding the NaI crystal.

Peter
You do not have the required permissions to view the files attached to this post.

stamasd
Posts: 124
Joined: 29 Oct 2017, 02:12

Re: NORM: the lead I used to build my shield with. :)

Post by stamasd » 08 Nov 2026, 11:17

Very interesting, thanks for posting that.
I don't have any blocks of tungsten, but I do have a container with 100g of tungsten powder, perhaps I should test that.

I may have an idea of why you see thorium in your tungsten. Among other uses, tungsten is sintered into TIG welding electrodes. Pure tungsten has a poor electron extraction efficiency, which means it's not that good at initiating and maintaining an arc. Because of that impurities are intentionally added during the sintering process, the most classic of which is thorium dioxide (it increases the electron extraction efficiency, therefore the electrodes are better).

I'm not saying that your tungsten blocks were made from recycled electrodes... but maybe they were manufactured in a facility that also makes thoriated TIG electrodes, and cross-contamination occurred.

You can actually test this if you find a thoriated tungsten electrode (the ones marked at an end with a dark red circle). I did that in the past and clearly saw thorium peaks. The electrodes marked with different colors than red don't have thorium (green for pure tungsten, blue for lanthanum, violet for a mix of rare earths, grey for cerium, brown or white for zirconium etc.)

In the past you could have also blamed it on the manufacture of vacuum tube filaments, which are also typically thoriated, for the same reasons... but that use has fallen off considerably in the past 40-50 years.

User avatar
Peter-1
Posts: 172
Joined: 07 Oct 2016, 01:45

Re: NORM: the lead I used to build my shield with. :)

Post by Peter-1 » 09 Nov 2026, 21:50

I have measured some thorium-containing electrodes specifically, WT40 with 4% thorium. The spectrum is as expected.
You do not have the required permissions to view the files attached to this post.